4/17/2023 0 Comments Camworks post processor library![]() ![]() STEP 1: Getting something to appear in the "Insert Post Operation" dialog box.Īdd another operation in your_machine.SRC after all the existing operations. NOTE: before you try any of this junk you should at least figure out how to edit the relevant files in notepad, compile them using UPG, and then reload your post processor in camworks. ![]() And good luck finding any documentation on that. I'm not going to attempt to "describe" them since they all seem to have similar aspects and its not clear to me what can or cannot go in any of them. ![]() "your_machine" means whatever the filename for your particular machine is. I scoured the internet and all I could find were several versions of the same document, which basically just lists all the identifiers, commands, and variables, but doesn't provide an overall picture of the structure. I'm an experienced programmer and this is garbage. The Camworks post processor architecture is poorly documented and disorganized. I was expecting the mandatory and optional stop commands (M00/M01), but those aren't there either. When I try to use the "Insert Post Operation", there isn't anything listed there. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |